Juniper SSG-140-SH Especificações descarregar pdf (Página 37)

Tools and Parts Required  37

Chapter 4

Servicing the Device

This chapter describes service and maintenance procedures for the SSG 140 device.

It includes the following topics:

 “Tools and Parts Required” on page 37

 “Replacing a PIM” on page 38

 “Upgrading Memory” on page 40

 “Replacing the Fuse” on page 43

Tools and Parts Required

To replace a component on an SSG 140 device, you need the following tools and

parts:

 Electrostatic bag or antistatic mat

 Electrostatic discharge grounding wrist strap

 Flat-tip screwdriver, 1/8 inch

 Number-2 phillips screwdriver

NOTE: For safety warnings and instructions, refer to the Juniper Networks Security

Products Safety Guide. The instructions in the guide warn you about situations that

could cause bodily injury. When working on any equipment, be aware of the

hazards involved with electrical circuitry, and follow standard practices for

preventing accidents.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 59 60

Sem comentários

Juniper SSG-140-SH Especificações Página 37